A. Command…… B. Specify start point of arc or (center) C. Specify center point o

Question

A. Command……

B. Specify start point of arc or (center)

C. Specify center point of arc

D. Specify start point of arc

E. Specify end point of arc or (Angle/Chord/Length);

F. Specify included angle;

(5). Give the command, entries, and actions required to draw anarc tangent to the end point of a previously drawn line;

A. Command …….

B. Specify start point of arc or (center)

C. Specify end point of arc.

6. Give the command, entries, and actions needed to draw anellipse with the AXIS, END option.

A. Command……

B. Specify axis endpoint of ellipse or (ARC/CENTER)

C. Specify other endpoint of axis;

D. Specify distance to other axis or (ROTATION)

(7). Give the command, entries, and actions needed to drawa   hexagon measuring 4inchs (102mm) across the flat.

A. Command………

B, Enter number of sides, <current>;

C. Specify center of polygon or (EDGE)

D. Enter an option (INSCRIBED in circle /Circumscribed aboutcircle) <current>

E. Specify radius of circle……

Explanation / Answer

hi, You should be able to understand the CADhomework problem you are asking about by following the steps below: (7)   command : pol           Enternumber of sides : 6           Specifycenter of polygon or (EDGE) : edge           Enteran option (INSCRIBED in circle /Circumscribed about circle) :inscribed           thenSpecify lenght of polygon: 4              "I hope this helps! Best ofluck with the rest of your coursework."    (7)   command : pol           Enternumber of sides : 6           Specifycenter of polygon or (EDGE) : edge           Enteran option (INSCRIBED in circle /Circumscribed about circle) :inscribed           thenSpecify lenght of polygon: 4              "I hope this helps! Best ofluck with the rest of your coursework."   

Related Questions

Navigate

• Browse (All)
• Browse A
• Subjects

---