I have the code just need help setting it. The code is below, thank you. Here is
ID: 3882923 • Letter: I
Question
I have the code just need help setting it. The code is below, thank you.
Here is the code.
I. Monitoring wells were installed near a contaminated site (oil leak) for use in site characterization and monitoring. Table 1 presents field data. Table 1. Well locations and field measurements taken FIELD DATA COMPUTATIONS Distance From the Distance from the toptop of the casing toWater Table Elev. (ft) WellEast North Elevation at top of the casing (ft)of the casing to water t bott om of the table (ft) well (ft 13.12 8.96 18.63 11.09 10.35 11.31 7.63 22.77 14.99 12.62 14.69 2.81 MW-2 261.3 132.7 MW-357.9121.8 MW-4 124.5 209.4 MW-5 210 202.8 MW-5a 237 194.1 MW-6 187.5 79.5 MW-7263.7 -9.9 MW-8114.3 5.1 MW-957.940.5 MW-10 240 159.3 MW-12 116.114.8 240.54 240.87 241.15 241.36 241.38 240.73 239.82 240.68 240.72 241.4 240.17 5.11 3.29 3.48 2.39 3.89 4.31 3.11 3.35 1) Prepare a contour map that shows water table elevations using any convenient contour interval. If you use the Matlab code I am providing (Field contour students.m), answer the questions I asked you within the linesExplanation / Answer
Let table is stored in an excel file named "input.xlsx" then In starting this code will have these lines to load and process data:
Matlab code
filename = 'input.xlsx'; % input filename
data = xlsread(filename); %it will read numeric data from the first worksheet of the excel file
East = data(:,1);
North = data(:,2);
Water_Elevations = data(:,3);