Question #2 (a) Physical representations of the Instek GFG-8216A Function Genera
ID: 2267071 • Letter: Q
Question
Question #2 (a) Physical representations of the Instek GFG-8216A Function Generator (FG) and the Tektronix TDs-320 Oscilloscope (DSO) are shown below. The test circuit shown at the lower left is to be implemented using the RLC-chassis, the FG and the DSO. Show (draw) the necessary connections to be made between the three units. OSCILLOSCOPE(DSo) FUNCTION GENERATOR Red (Note Red Blk terminal reference)- Blk Input v. TEST CIRCUIT RLC Chassis (b) Assume that you have made the proper connections for (a) above and that you next wish to change the test circuit to have only R and C in series, with Vc as the output. Using a dashed line, show the (single) additional connection required which will accomplish the change. (c) Two sinusoidal waveforms of the same frequency, f, are displayed on the oscilloscope. The waveforms are not in phase and the cursors were used to measure the following values: Time between two adjacent peaks of the same waveform = (choose between 200 to 400 Time between adjacent peaks of the first and second waveform ..s With the values that you have chosen, the frequency is f- .Hz and the phase-shift between the two waveforms is = degrees. (choose between 10 to 40 us)Explanation / Answer
c)
the time between two adjacent peaks (Time period)=300micro seconds
the time between adjacent peaks of the first and second waveform=30micro seconds
frequency(f)=1/300=3.33 kilohertz
phas=2*pi*30/300=pi/5