Renewable Energy Systems (EGN-4913) (b) Make sure to have 300 series cells in co

Question

Renewable Energy Systems (EGN-4913) (b) Make sure to have 300 series cells in configuration of Solar Panel block before running the simulations Solar Cell This block models a solar cell as a paralledl combination of a current source, two exponential diodes and a parale resistor, Rp, that are connected in series with a resistance Rs. The output current I is given by where is and 1s2 are the diode saturation currents, Vt is the thermal voltage, N and N2 are the quality factors diode emission coefficients) and Iph is the solar-generated current. reduced complexity can be specfied in the mask. The quality factor varies for amorphous cells, and has a value in the range of 1 to 2. The physical signal Input Ir is the Irradiance (light intensity) in W/m 2 Models of current Iph is given by Ir*(ph0/r0) where Ipho is the measured sclar- falling on the cell. The solar-generated generated current for irradiance Iro. Settings 300 Number of series cells: Task: (1) Fill in the table with Solar irriadiance of 1000 W/m2 and find: (a) Open Circuit Voltage (Voc) and Short Circuit Current (Isc) (b) Maximum Power Point (c) Write your observations

Explanation / Answer

When circuit is being shorted or open, the current will be known as short circuit current. Just opposite to that if current is approximately nill, then voltage will be the maximum.

& Power will transmitted to another end wirelessly.

Related Questions

Navigate

• Browse (All)
• Browse R
• Subjects

---