Following the example we did in class, do a board layout plan for the following
ID: 3349746 • Letter: F
Question
Following the example we did in class, do a board layout plan for the following circuit: You have to look up the data sheets for the LT1086-5, LT1013. V1 is a standard 9 volt battery, and all the parts are "through hole". Label the test points in, V+, x1, x2, out1, and out2 (The bread board pattern is on the next page.) U3 IN V1 ADJ LT1086-5 0 R1 R2 R4 R3 x2 10k 10k +90k U2 +90k out2 out1 LT1013 LT1013 It is highly recommended to turn in a screen grab of your Fritzing layout and the Fritzing Layout file (.fzz) rather than a scan of your draft drawing Checklist: Are you using the right pinout for the parts in the schematic? Did you label the orientation of each chip with a dot or pin names? Is Vin on the layout as a voltage source? Did you check for inadvertent shorts? Did you have a friend check you work? Are all the test nodes labeled?Explanation / Answer
1) yes we are using proper pinout for this schemetics given in the above diagram.2) yes we have properly connected the chip and every pin of the circuit. 3) we have connected the vin pin of the layout to the voltage source.4) yes our in adversme3nt source is connedcted properlly 5) every nodes are labeled properly before connecting to the source supply